Description

Spill Decontamination:-

Klean Up may be used to decontaminate soils which have been contaminated by spills of organic herbicides, fungicides, insecticides, gasoline, motor oil, or hydraulic fluid . As quickly as possible after the spill, Apply 1-2 litres per 100m2 of contaminated area. If spill severe, apply full strength and wash into soil and root zone area 10-15 cm. deep. Any type of spray equipment may be used . For spot treatment of small spills, apply undiluted product directly from the container or from a common sprinkler can .

Lawn/Turf Reseeding:-

Klean Up can be used to reseed turfgrass earlier than normal on soils which have been treated with pre-emergence crabgrass herbicides or other organic herbicides . Treat the soil by applying 1-2 litres of KLEAN UP in sufficient water for good distribution per square meter of turf area. Grass areas should be washed free of heavy charcoal deposits. Areas where herbicidal effect has been terminated may be seeded within 24 hours of application.

Spray Equipment Decontamination:-

After cleaning the spray tank and hoses with another suitable cleaner, fill the tank half-full with clean water. After pesticide use, fill spray tank halfway with water, then add 1 litre of KLEAN UP per 100 litres of water. Fill the remainder of spray tank with water and circulate through the system for 10 minutes, and then the nozzles for another 10 minutes. Drain system and rinse with clean water until all signs of KLEAN UP are gone.

Bare Root Transplanting:-

Klean Up  may be used to protect the root system of transplants against injury due to trace contamination . Bare root transplants are very susceptible to damage at that time . Prepare a slurry of 1 part product and 1 part water . Dip roots thoroughly into the slurry and plant while wet .

Protective Barrier:-

To protect established trees and shrubs from damage due to leaching of persistent herbicides, incorporate a 50% solution of Klean Up  in water into a barrier trench 4-8 inches deep or as required . One gallon of product will protect approximately 15-20 linear feet .

Seed Protection:-

Klean Up  will protect seed rows from herbicide treatment when applied as a layer over seed rows . Apply a slurry mix of 3 gallons product in 3 gallons water per 1,000 sq ft banded directly over the seedbed.